Scanning fault messages
2. Acknowledge the fault message with
OK. The symbol " " no longer
flashes.
Note
■ If you have connected up signalling
equipment (e.g. an alarm) for fault
messages, this is deactivated
when the fault message is
acknowledged.
■ If the fault can only be fixed at a
later point in time, the fault mes-
sage will reappear the following
day.
Calling up an acknowledged fault
message
Press OK for approx. 4 s.
Note
If there are several fault messages, you
can scan these in sequence by pressing
/ .
(cont.)
Scanning
21