Settings - Panasonic SA-HE70 Operating Instructions Manual

Step
1 2
Change the settings to suit your speakers and units to the environment in which you are using them. Before making any changes, read the
descriptions of the settings, note the factory settings and ranges, and refer to the equipment's instructions.
1
SIZE
Set the size to suit
your speakers
2
DISTANCE
Enter the distance of
the front, center and
surround speakers
from the seating
position
3
FILTER
Change the cut-off
for bass output from
the front speakers
4
D-INPUT
Digital input
5
Adjusting
speaker output
level
8
RQT6193
3

Settings

4
LARGE:For speakers that can reproduce a full sound range, particularly
the bass range below 100 Hz.
SMALL: For speakers that cannot adequately reproduce the bass range.
This setting is sufficient for most speakers if you are using a
subwoofer.
NONE: For speakers you haven't connected (center or surround).
The factory settings are: FRONT:
CENTER and SURROUND:
For the subwoofer (SUB-WFR), select YES if you have connected one
(factory setting), or NO if you have not.
Change the distance so that the sound from all the speakers (except for
the subwoofer) reaches you at the same time.
You can select distances between 3 and 30 feet at one-foot intervals.
The factory settings are: FRONT and CENTER:
SURROUND:
If you set the front speakers to "SMALL", the filter is set to 100 Hz. Raise
the cut-off if the bass from the front speakers is unsatisfactory so that this
bass is output through the subwoofer.
You can raise the cut-off from 100 Hz to either 150 Hz or 200 Hz.
Change these settings to suit the connections you have made to the three
digital input terminals, COAX, OPT1 and OPT2, so that the correct source
is selected when you turn [INPUT SELECTOR].
The factory settings are: CD: COAX
DVD:OPT 2
TV: OPT 1
Adjust the level of the other speakers based on the output of the front
speakers. (Adjust the volume of the front speakers with [VOLUME].)
C (center), SR (surround right), and SL (surround left) can be adjusted
between –10 dB and +10 dB, with 0 being the level of the front speakers.
Adjust center and surround output to the same apparent level of the front
speakers.
For SW (subwoofer), you can select "---" so there is no output, "MIN" for
minimum output, a level between 1 and 19, or "MAX" for maximum output.
Adjust subwoofer output so it is balanced with the front speakers.
Subwoofer output is easily influenced by the source. You can also change
its level while playing something for better effect ( \ page 13).
LARGE
SMALL
10 FEET
5 FEET
Press at the same
time to enter the
setting mode.
Turn SPEAKERS
on.
w q
SFC MODE
SPEAKERS