Introduction; Rohs Requirement; Safety Notice - BenQ G2200W Service Manual

22" LCD Color Monitor

2. Introduction

2.1 RoHS requirement

Overview
-Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment (RoHS) Directive
2002/95/EC is published in the Official Journal 13 February 2003 (OJ L37, 13.2.2003, p.19).
-Purpose: Reduction of the environmental and health risks posed by hazardous materials in EEE.
-It is complementary to & running in parallel with the WEEE Directive.
-Transposed into national law by 13 August 2004. And comes into effect 1 July 2006.It is similar to the WEEE
Directive, except:
Applies to new EEE placed on the market after 1 July 2006.
Includes household filament light bulbs & luminaries.
Excludes: Medical devices or monitoring & control equipment (WEEE categories 8 & 9);Spare parts for the repair of
EEE placed on the market before 1 July 2006; Re-used EEE originally placed on the market before 1 July 2006.

2.2 Safety Notice

FCC Notice
FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
NOTICE :
1. The changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
2. Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission
limits.
3. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to
this equipment. It is the responsibilities of the user to correct such interference.
3
BenQ G2200W