Drainage - Miele PW 5065 Operating Manual

Drainage

There are two drainage extras for this
machine:
Drain valve
The machine is drained with a
motorized drain valve. A connection
can be made to an on-site floor drain
(gully with an air gap) on an angle.
Drain pump
The wash water is drained using a
pump with a 3 ft (1 m) delivery height.
Make sure there are no kinks in the
drain hose. The elbow on the end of the
drain hose can be turned or removed if
necessary.
Possible connections:
1. Directly into a sink: Hook the hose
over the edge of the sink and secure
it firmly (e.g. by tying the hose to the
water faucet).
2. To a stand pipe: Place the drain
1
hose into a 1 /
and secure it firmly.
3. To a floor drain: The machine is
equipped with an air gap/
anti-siphoning system so that no
minimum drain height is required.
" (4 cm) stand pipe
2
If necessary the drain hose can be
extended up to 16' 5" (5 m). The hose
extension can be purchased from your
Miele dealer or Miele.
Installation
51