Panasonic PT-DW5100EL Service Manual page 11

e. Set the mean value (omission below decimal point) of "A" and "B" to the CW INDEX setting value.
4. POWER ON SHUTTER
· OPEN: Opens the shutter when power ON.
· CLOSE: Closes the shutter when power ON.
5. POWER OFF SHUTTER
· IGNORE: Does not control the shutter when power OFF.
· OPEN: Opens the shutter when power OFF.
· CLOSE: Closes the shutter when power OFF.
6. ERROR OSD
Displays the lamp status with OSD when you do not see the status LED lights because the rear projection, etc.
7. SIGNAL DATA ALL ERASE
Resets the setting value of each signal to the initial value of the factory shipment.
8. MODEL
Sets the model name.
· Set it when you install a new A-P.C.Board without maintenance (data transfer or IC replacement) of adjustment data etc.
according to the paragraph 7.2.1.
* Never set it to a model name different from the model that installs the new A-P.C.Board. If a different model name is set,
it becomes impossible to output normal pictures after the next startup.
* When a new A-P.C.Board is installed without maintenance of adjustment data, it is required to adjust the color wheel.
4.3.2. SUB KEYSTONE
"SUB KEYSTONE" is added to KEYSTONE in the "POSITION" menu.
If KEYSTONE and "Lens shift" are used at the same time, the right and left is corrected in the unbalance.
At this time, only the right side can be corrected by SUB KEYSTONE.
PT-D5700U / PT-D5700E / PT-D5700UL / PT-D5700EL / PT-DW5100U / PT-DW5100E / PT-DW5100UL / PT-DW5100EL
11