Charcoal Water Filter; Setting Up Your 12-Cup Coffeemaker; Programming Your 12-Cup Coffeemaker - Cuisinart SS-15 Series Instruction Booklet

CHARCOAL
WATER FILTER
INSERTING THE WATER FILTER
1. Remove the filter from the polybag and
soak, fully immersed, in cold tap water
for 15 minutes.
2. Lift the water filter holder out of the water
reservoir the 12-Cup Coffeemaker side.
3. Press down on the filter compartment and
pull toward you to open.
4. Place filter into the holder and snap closed.
Be careful – improper placement can tear
the filter skin.
5. Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
6. Allow the filter to drain completely.
7. Slide the water filter holder back into the
channel in the water reservoir, pushing
down to the base of the unit.
NOTE: Repeat steps 1-7 above on the
Single-Serve side.
NOTE: We recommend changing the water
filter every 60 days or after 60 uses, and more
often if you have hard water.
Replacement filters can be purchased in stores,
by calling Cuisinart Consumer Service, or at
www.cuisinart.com
SETTING UP YOUR
12-CUP COFFEEMAKER
INITIAL CLEANING
Perform an initial cleaning before making
your first beverage. Follow these
instructions, without adding coffee.
1. Insert charcoal water filter if you haven't
already. Instructions above.
2. Fill water reservoir.
3. Make sure carafe is in place.
4. If you haven't already, plug the power
cord into an independent outlet. Power on
unit by pressing the power switch on side of
the unit.
5. Turn function knob to BREW.
6. Press the BREW button and allow brew
cycle to run.
7. The one-time cleaning process is
complete. Discard hot water. Your
Coffeemaker is ready to use.
PROGRAMMING YOUR
12-CUP COFFEEMAKER
SETTING THE CLOCK
When the Coffeemaker is plugged in and
power switch is turned on, 12:00 will flash.
Turn the Function knob to CLOCK
Press Hour and Minute buttons to select the
desired time. Hold buttons down to scroll
through the digits, or press and release
to advance one digit at a time. When scrolling,
the numbers will advance slowly and then
speed up. When the number displayed
approaches the desired time, press and
release to advance one digit at a time.
Be sure the PM indicator is on if a PM time
is desired.
To finish setting the clock, turn the Function
knob to any other setting or simply wait until
the numbers stop blinking.
8