Table 2-1. Table 3-1. Table; Scsi Cables; Figure 2-2. Rear View Of Tape Drive - HP 5243-2SE Installation And User Manual

Installing and Configuring the Tape Drive for the
NonStop S-Series Server
Note. The tape drive's SCSI IDs come preconfigured to SCSI ID 5. If you need to change
the SCSI IDs, use a screwdriver. Do not use a lead pencil.
3. Complete these steps first for the drive on the left side of the unit and then for the
tape drive on the right:
a. Connect one end of the SCSI cable to the corresponding SCSI port at the rear
of the tape drive. For the location, see

Figure 2-2. Rear View of Tape Drive

SCSI ID SCSI Ports
b. Hand tighten the screws to secure the cable to the unit.
c. Connect the opposite end of the SCSI cable to the NonStop S-series server.
The tape drive can connect to the
CRU
on the NonStop S-series server.
You can use any of the SCSI cables listed in
Table 2-1. SCSI Cables
Model Number
519-003W
519-015W
519-020W
519-023W
5243-2SE Tape Drive Installation and User's Guide —542757-003
Fan Power Connectors
ServerNet/DA
Description
3 meter copper SCSI cable
15 meter copper SCSI cable
20 meter copper SCSI cable
23 meter copper SCSI cable
2 -2
Figure 2-2 and Figure
Fan SCSI Port SCSI ID
IOMF2 CRU, or PMF
,
Table 2-1.
Installation
2-3.