Audio Adjustment; Changing The Display Language; Option Settings; Rgb2 Select, Rgb/Yp B P R - Panasonic PT-L735E Operating Instructions Manual

Audio adjustment

Select the items by pressing the F
or G buttons on the remote control
unit or the projector.

Changing the display language

Use the F, G, I and H buttons on the projector or remote control unit to
select a language, then press the ENTER button to accept the setting.
44-E
NGLISH
VOLUME
Press the I or H buttons to adjust
the volume of the sound output by
the projector's built-in speaker.
MUTE
Set the MUTE to "ON" pressing the
I or H buttons to turn off the
volume of the sound output.
To release muting, set to "OFF"
pressing the I or H buttons.
AUDIO MODE
Set to "VOICE" by using the I and
H buttons when the sound output is
mainly conversations. The sound
will become easier to hear.

Option settings

Use the F and G buttons on the
projector or remote control unit to
select an item, then press the I or
H buttons to change the setting.
OSD
ON
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
OFF
Use this setting when you do not
want the current input name to be
displayed.
AUTO SEARCH
ON
The input signal will be detected and
selected automatically when the Input
select (RGB, VIDEO) buttons are
pressed for a few seconds. (page 14)
OFF
AUTO SEARCH is disabled.
NOTE:
B AUTO SEARCH will not function
when the input signal is being
projected.
(PT-L735NTE only)
AUTO SEARCH will not function
when NETWORK or SD CARD is
selected. NETWORK and
SD CARD cannot be searched even
when these signals are being input.
AUTO SIGNAL
This should normally be set to "ON".
ON
AUTO SETUP will be carried out
automatically when the input signal
is changed. (page 27)
OFF
AUTO SETUP will not function
when the input signal is changed.
AUTO KEYSTONE
This should normally be set to "ON".
ON
During automatic setup, the angle of
tilt of the projector is detected and
keystone distortion is corrected
automatically.
OFF
Use this setting when you do not
want automatic keystone correction
to be carried out during automatic
setup, such as when the screen
itself is at an angle.
RGB2 SELECT
This setting is used to select the
function of the RGB2 IN/RGB1 OUT
connector.
E -45
NGLISH