Switching The Input Signal; Enlarging The Centred Area - Panasonic PT-FW300E Operating Instructions Manual

Remote control operation

Switching the input signal

You can switch the input method manually by
pressing the COMPUTER, NETWORK and
VIDEO buttons. Press the required button
several times or I H to cycle through the
input methods as follows. The actual
projected image will be changed in a while.
The graphical guidance will be displayed on the upper
right of the projected image and you can confirm the
selected input method which is highlighted in yellow. See
"INPUT GUIDE" on page 40.
NOTE:
• If you select an unplugged input method, the guidance
will blink on and off several times.
• See "List of compatible signals" on page 54.
• See "Connections" on page 21.

Enlarging the centred area

You can enlarge the projected image down to a centred area for emphasizing within the range of 1x to 2x.
Enlarging the image
1. Press the DIGITAL ZOOM +/- button once.
The centred area of the image will then be enlarged
to 1.5x.
2. Adjust the image size by pressing the DIGITAL
ZOOM +/- button.
The image size will be changed in steps of 0.1.
NOTE:
• When the COMPUTER signal is projected, the enlargement range will be changed to 1x to 3x. When the FRAME LOCK
in POSITION menu is set to ON, the enlargement range is 1x to 2x. See "FRAME LOCK" on page 39.
• When the input signal is changed while the DIGITAL ZOOM is activated, the DIGITAL ZOOM will be cancelled.
• While DIGITAL ZOOM is activated, FREEZE is not available.
E
NGLISH - 28
Pressing the COMPUTER button
COMPUTER1
F
NOTE:
• Only when the COMPUTER2 SELECT is set to INPUT,
the COMPUTER2 is selectable.
Pressing the NETWORK button
Only for the network connection operation. See CD-
ROM contents for more detailed information.
Pressing the VIDEO button
VIDEO
Pressing the INPUT SELECT
button on the projector
COMPUTER1
F
DVI
F
NETWORK
Shifting the centre point
Press F G I H to shift the centre point.
COMPUTER2
H
G
DVI
S-VIDEO
IH
COMPUTER2
H
G
S-VIDEO
G
VIDEO
I