Read This First; Minimum Required Setting Screen - Panasonic PT-FW100NTU Operating Instructions Manual

Read this first

Minimum required setting screen

When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
LANGUAGE
Select the required language setting.
LANGUAGE
PLEASE SELECT LANGUAGE
SELECT
Press F G I H buttons of the Remote control or
Control panel on the projector to highlight the
required language, and press ENTER to proceed to
the next setting.
OPTION
Select the current projection method, screen size
and fan speed setting. If you need return to the
previous setting, press the RETURTN button.
OPTION
INSTALLATION
SCREEN FORMAT
HIGHLAND
SELECT
Press the ENTER button to start the projection.
Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialized. See "INITIALIZE ALL" on page 36.
You can change the settings from the MAIN MENU. See "Menu Navigation" on page 27.
E
NGLISH - 10
ENTER
FRONT/DESK
16:10
OFF
RETURN
ENTER
INSTALLATION
Press I H buttons of the Remote control or
Control panel on the projector to select the
required installation method. Press G to proceed to
the HIGHLAND setting.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear
SCREEN FORMAT
Select the required screen format by pressing I
H.
16:10 When project on a 16:10 or 4:3
screen.
16:9 When project on a 16:9 screen.
HIGHLAND
If you use the projector at high elevation, the
HIGHLAND setting need to be ON to set the fan
speed high. Press I H to select the required
option. If you need to return to the INSTALLATION,
press F.
OFF The fan speed is low.
ON The fan speed is high.
NOTE:
• At 1 400 m (4 593 ft) above sea level, the setting must
be ON.
• The loudness of fan noise depends on the HIGHLAND
setting.