LAMP RUNTIME
You can check how long the lamp has been used.
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Replacing the Lamp unit" on
page 43.
• When the lamp unit is replaced with the new one
(ET-LAF100), the setting will be reset to "0".
POWER OFF TIMER
You can set the off timer to switch off the POWER of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
DISABLE
15 MIN.
20 MIN.
25 MIN.
30 MIN.
35 MIN.
DIRECT POWER ON
You can switch the projector start up status for when the
Mains lead is connected while the MAIN POWER is on,
or for when the MAIN POWER is switched on while the
Mains lead is connected. Press I H to select the
required option.
OFF
The projector will start from the
standby mode or the projecting
mode.
ON
The projector will start from the
projecting mode.
NOTE:
• When the projector is started from the projecting mode,
pressing the POWER button procedure is skippable.
CONTROL PANEL
You can turn off the function of the control panel buttons
on the projector body. Press I H to select the required
option.
AUTO SETUP
You can turn off the AUTO SETUP function for when the
COMPUTER signal is detected.
60 MIN.
55 MIN.
NOTE:
50 MIN.
SIGNAL SEARCH
45 MIN.
You can turn off the auto signal detecting system.
40 MIN.
NOTE:
INSTALLATION
When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 17.
INVALID
Invalidate the control panel buttons
Confirmation screen will be
displayed.
VALID
Validate the control panel buttons
AUTO
When the projector detect a
COMPUTER signal, adjust the
projected image position
automatically for SIGNAL SEARCH,
DOT CLOCK and CLOCK PHASE.
BUTTON
Only when the AUTO SETUP button
is pressed, the projected image
position will be adjusted for DOT
CLOCK and CLOCK PHASE. See
"Remote control" on page 13.
• Usually the recommended setting is AUTO.
ON
Detect the input signal from the
terminals and project the image.
OFF
Deactive
• SIGNAL SEARCH is not available when any input
signal is projecting.
• Usually the recommended setting is ON.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear
OPTION menu
E
NGLISH - 37