Table of Contents
Advertisement
Troubleshooting
Before requesting service, make the below checks. If you can't fix the system as described below, or if something not listed
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
For detailed instructions, contact an authorized servicenter in the U.S.A. and Panasonic Canada Inc. Customer Care
Centre in Canada.
In the U.S.A., call 1-800-211-7262, e-mail consumerproducts@panasonic.com, or visit www.panasonic.com
In Canada, call 905-624-5505 or visit www.panasonic.ca
Reference pages are shown as black circled numbers
Common problems
"E" is displayed
"UO1" is displayed
"UO2" is displayed
CD
CD won't play or CD display is incorrect
Cassette deck
Recording not possible
Poor sound quality
Radio
A lot of noise or difficult to tune
Remote control
The remote control doesn't work.
The unit can't be turned on from the remote
control.
Specifications
Radio
Frequency range
FM
AM
CD player
Sampling frequency
Decoding
Beam source
No. of channels
Wow and flutter
D/A converter
Tape recorder
Track system
Monitor system
Recording system
Erasing system
Frequency response
Normal position
22
RQT5671
87.9–107.9 MHz (200 kHz steps)
87.5–108.0 MHz (100 kHz steps)
520–1710 kHz (10 kHz steps)
16 bit linear
Semiconductor laser (wavelength 780 nm)
2 channel, stereo
Below measurable limit
MASH (1 bit DAC)
4 track, 2 channel, stereo
Variable sound monitor
Multi Pole magnet
50 Hz–14 kHz
6 6 6 6 6
.
Indicates incorrect operation. Read the instructions.
Replace the batteries or use household AC power.
Batteries haven't been inserted. Insert batteries or use household AC
power. ("UO2" appears only if you have inserted memory batteries.)
Ä
Clean the CD
Wait for about an hour for condensation to clear and try again.
Make sure the label is facing up.
Replace the CD if it is scratched, warped, or irregularly shaped.
Have the cassette's tabs been removed? Cover the holes with tape.
9
Clean the heads.
Interference may be caused by other equipment. Turn the other equipment
off or separate this unit from them.
Interference may occur if a remote control from other equipment is used.
Check the batteries are inserted correctly.
Replace the batteries if they are worn.
Use the power button on the main unit if you are using batteries to power
6 8
the unit.
General
Speakers
Full Range
Jacks
Output
Power requirement
AC
44.1 kHz
Battery
Memory back-up for computer/clock
Dimensions (W
Mass
AC bias
Specifications are subject to change without notice.
Mass and dimensions are approximate.
6
Ä
8
8
PHONES: 3.5 mm stereo (16–64 Ω)
Power consumption: 17 W
In standby mode: 1.2 W
12 V (Eight R20, D, UM-1 batteries)
6V (Four R6, AA,UM-3 batteries)
×
H
D)
380
X
X
×
14
31 /
˝
6
7 /
32
without batteries
6
Ä
Ü
7 cm 5.4 Ω
2
X
120 V, 60 Hz
×
158
250 mm
×
˝
9
27 /
˝ inch
32
32
3.7 kg (8.2Ibs)
Hide quick links:
Advertisement
Table of Contents
