Honda 2006 S2000 Owner's Manual page 53

NOTE: The temperature must be
stabilized before doing this
procedure.
To adjust the outside temperature
indicator, make sure the outside
temperature indicator is shown in
the display, then press and hold the
TRIP button for 10 seconds (the
TRIP A or B is also reset). The
following sequence will appear for 1
second each: 0, 1, 2, 3, 4, 5,
3, 2, 1, 0 (U.S.) or 0, 1, 2, 3,
− − −
3, 2, 1, 0 (Canada).
− − −
When it reaches the desired value,
release the TRIP button. You should
see the new outside temperature
displayed.
In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.
Check Fuel Cap Indicator
If your fuel fill cap is loose or
missing, a ''CHECK FUEL CAP''
message appears on the information
display after you start the engine.
The message goes from CHECK to
FUEL, then to CAP repeatedly. You
will also hear a beep.
Turn the engine off, and confirm the
fuel fill cap is installed. If it is, loosen
5, 4, the cap, then retighten it until it
− −
clicks at least once. When you
restart the engine, the message
appears again. To clear the message,
press and hold the RESET button
until the odometer display returns.
If the system still detects a loose or
missing fuel fill cap, the malfunction
indicator lamp (MIL) comes on.
Turn the engine off, and check or
retighten the fuel fill cap until it
clicks at least once. The MIL goes
out after several days of normal
driving once the cap is tightened or
replaced. If it does not go out, have
your dealer inspect the vehicle. For
more information, see page
Gauges
183 .
53