Releasing - Mercedes-Benz B-Class Electric Drive Operator's Manual

Hide thumbs Also See for B-Class Electric Drive:
Table of Contents

Advertisement

Engage seat belt tongue ; in belt
X
buckle :.
If necessary, pull upwards on the shoulder
X
section of the seat belt to tighten the belt
across your body.
The shoulder section of the seat belt must
always be routed across the center of the
shoulder. Adjust the belt outlet if necessary.
To raise: slide the belt outlet upwards.
X
The belt outlet will engage in various posi-
tions.
To lower: hold belt outlet release ? and
X
slide belt outlet downwards.
Let go of belt outlet release ? in the
X
desired position and make sure that the
belt outlet engages.
All seat belts except the driver's seat belt are
equipped with a special seat belt retractor to
securely fasten child restraint systems in the
vehicle. Further information can be found
under "Special seat belt retractor"
(
page 57).
Y
Seat belt for the center rear seat
If the left-hand rear seat backrest is folded
down and back up again, the rear center seat
belt may lock. The seat belt can then not be
pulled out.
To release the rear center seat belt: pull
X
the seat belt out approximately 1 in
(25 mm) at the belt outlet on the backrest
and then release it again.
The seat belt is retracted and released.
Occupant safety
Releasing seat belts
! Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt. Dam-
aged seat belts can no longer fulfill their
protective function and must be replaced.
Visit a qualified specialist workshop.
Basic illustration
Press release button :, hold belt
X
tongue ; firmly and guide it back towards
belt outlet =.
Belt warning for the driver and front
passenger
The 7 seat belt warning lamp in the instru-
ment cluster is a reminder that all vehicle
occupants must wear their seat belts. It may
light up continuously or flash. In addition,
there may be a warning tone.
Regardless of whether the driver's seat belt
has already been fastened, the 7 seat belt
warning lamp lights up for six seconds each
time the drive system is started. If the front
doors are closed and the driver or front-
passenger seat belt has not been fastened,
the 7 seat belt warning lamp lights up
again after the six seconds. As soon as the
driver's and front-passenger seat belts are
45
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents