Panasonic CF-T1 Series Operating Instructions Manual page 15

3
Log on to Windows
Windows 2000
After confirming that the hard disk drive indicator (
name and password, then select [OK]. Until the correct user name and password are
entered, the computer will not operate.
Windows XP
After confirming that the hard disk drive indicator (
user and input the password, then select
computer will not operate.
4
Select your application
You are able to start working on your computer.
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad, the touchscreen (only for models with touchscreen) or an external mouse (when
one is connected) for a certain interval of time, the power to the LCD and hard disk
may be turned off. The LCD will resume operation when the touch pad, the touchscreen
(only for models with touchscreen) or an external mouse (when one is connected) is
used or a key is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode (
will resume by sliding the power switch.
Windows XP
When switching to a different user with the Fast User Switching function, it may
not be possible to set the settings of the display. In this case, log on with the
administrator authority again, not using the Fast User Switching function, and
try the operation once more.
) has turned off, input the user
) has turned off, select the
. Until the correct password is entered, the
"Standby/Hibernation Functions"). The computer
15