Resuming Operation - Panasonic Toughbook CF-48 Series Reference Manual

Standby/Hibernation Functions

Resuming Operation

When the computer enters either the standby or hibernation mode by the closing of the
LCD panel, it will resume when the LCD panel is opened. If the computer does not
resume when the LCD panel is opened, press the power switch.
Windows XP
If settings have been made for multiple users, select the "User" when operations re-
sume.
CAUTION
After the display returns, the computer needs a short period of time to reinitialize.
This takes about 30 seconds. Do not shut down or restart Windows, or enter
either the standby or hibernation mode again during this time, as this may subse-
quently cause Windows to operate abnormally.
Do not install or remove peripherals while your computer is in the standby or
hibernation mode; abnormal operation may result.
When operation resumes, serial devices such as a mouse, modem or PC Cards
may not function properly. In such cases, you will need to restart your computer
or reinitialize the individual devices.
Avoid the following until the power is completely turned off when turning off the
computer by using the standby or hibernation functions, or resuming operation
from the standby or hibernation.
• Touch the keyboard (excluding password input), touch pad, or power switch.
• Connect or disconnect the AC adaptor.
• Close the display.
Even when a password has been set in the Setup Utility,
when the computer resumes from the standby or hibernation mode.
If you want to use the security function when using the standby or hibernation
mode, use the Windows password as follows:
Windows 2000
Set the password in [Control Panel] - [Users and Passwords], then add the check
mark for [Prompt for password when computer goes off standby] in [Control Panel]
- [Power Options] - [Advanced].
Windows XP
Select the account to change in [Control Panel] - [User Account] and set the
password, then add the check mark for [Prompt for password when computer
resumes from standby] in [Control Panel] - [Performance and Maintenance] -
[Power Options] - [Advanced].
Press the power switch
9
does not appear