Integra DTR-40.7 Basic Manual page 89

 Consulting the Remote Control Code List
¼
Find the remote control code in the remote control code list�
1� Refer to the Remote Control Codes
manual for the corresponding remote control code�
● The codes in the Remote Control Code List are those
known as of the date of publication and may be
changed�
● The following Remote Mode buttons are
preprogrammed with remote control codes�
BD/DVD: Integra/Onkyo Blu-ray Disc/DVD player
CD: Integra/Onkyo CD player
STRM Box: Apple TV
● Only TV remote control codes can be entered for TV�
● Program a remote control code in accordance
with the input since each button also works as the
input selector� (For example, when the CD player
is connected to the CD jack, program the remote
control code for the CD player to CD)
2� Press and hold Display for 3 or more seconds while
holding down the Remote Mode button to which you
want to program the remote control code�
● The remote indicator lights in the input mode�
3� With the number buttons, enter the 5-digit remote control
code within 30 seconds�
● Programming is complete when the remote indicator
flashes twice� The remote indicator flashes once
slowly when programming the remote control code
fails� Try programming again�
 Remapping the Colored Buttons
¼
The colored button assignment on the AV receiver's remote
controller can be remapped to match that on the remote
at the back of the
controller of the component whose remote control code you
programmed to Remote Mode� However, you will not be
able to remap the colored buttons if Zone 2 is selected�
1� Hold down the Remote Mode button to map and A (Red)
simultaneously until the remote indicator lights (about 3
seconds)�
● Remapping is possible only for codes included in the
categories of the Remote Control Code List (DVD
player, TV, etc�)
2� Within 30 seconds, press the colored buttons from left to
right, in the order you want to remap�
● For example, if the colored buttons on the remote
controller of the other component are yellow, green,
blue, and red from left to right, press the buttons on
the AV receiver's remote controller in that order�
● Programming is complete when the remote indicator
flashes twice� The remote indicator flashes once
slowly when programming the remote control code
fails� Try programming again�
● Pressing any other button than a colored button
cancels the remap operation�
Operating Other Components with the Remote Controller
 Resetting the Remote Mode Buttons
¼
You can reset the remote control code registered in the
Remote Mode button to its default status� This operation
can be executed on a single Remote Mode button�
1� Press and hold Q for 3 or more seconds while holding
down the Remote Mode button you want to reset�
● The remote indicator will light�
2� Within 30 seconds, press the Remote Mode button
again�
● Resetting is complete when the remote indicator
flashes twice�
To reset all the remote controller settings: While holding
down RCV, press and hold Q for 3 or more seconds until
the remote indicator stays lit� Within 30 seconds, press
RCV again� Resetting is complete when the remote
indicator flashes twice�
En-57