Connecting With An Iphone/Ipad Via Wireless Lan - Yamaha PSR-A3000 Owner's Manual

Connecting with an iPhone/iPad via Wireless LAN

By using a USB wireless LAN adaptor (sold separately), you can connect the PSR-A3000 with an iPhone/iPad via
a wireless network. For general operating instructions, refer to the "iPhone/iPad Connection Manual" on the
website. This section covers only operations that are specific to the PSR-A3000.
Before starting operations, make sure that the USB wireless LAN adaptor is connected to the [USB TO DEVICE]
terminal and call up the setup display via [FUNCTION]  TAB [F] MENU 2  [H] WIRELESS LAN.
NOTE If the USB wireless LAN adaptor is not recognized by the instrument, "WIRELESS LAN" for the [H] button is not shown. When "WIRELESS LAN" is not shown even
though a USB wireless LAN adaptor has been connected, turn the instrument off then on again.
Infrastructure Mode
[A]/[B]
[G] UPDATE
[I] DETAIL
[1 ]/
WPS
[2 ]
[3 ]/
MODE
[4 ]
[5 ]/
INITIALIZE
[6 ]
[7 ]/
CONNECT
[8 ]
200
PSR-A3000 Owner's Manual
Selects the network.
Updates the network list on the display.
For setting the detailed parameters on the pages below. After making these
settings, press one of the [7 ]/[8 ] (SAVE) button to actually save
them.
IP ADDRESS: Sets the IP address and other related parameters.
OTHERS: When the instrument is connected to the network with the Infra-
structure Mode, the current time is shown on the Main display. You can
set the Time Zone via the [B] button and Daylight Saving Time via the
[C] button for your local time.
If you want to enter the host name, press the [A] button.
Connects this instrument to the network via WPS. Press this button fol-
lowed by the [G] (YES) button, then press the WPS button on your access
point within two minutes.
Switches to the Access Point Mode.
Initializes the connection setup to the default factory status.
Connects to the selected network.
If you select "Other" by using the [A]/[B] buttons, this calls up the Manual
Setup display in which you set the SSID, security method, and password.
After entering those, press one of the [7 ]/[8 ] buttons in the Man-
ual Setup display to connect to the network.