Selecting A Cut Off Frequency; Adjusting The Speaker Output Levels; Adjusting The Speaker Output Levels Using A Test Tone - Pioneer AVH-P7600D Operation Manual

Audio Adjustments
Selecting a cut-off frequency
You can select a frequency, under which
sounds are reproduced through the subwoo
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro
duced through a LARGE speaker or subwoo
fer.
1 Touch A.MENU and AUDIO and then
touch Sound Setting.
2 Touch Cross Over.
3 Touch the speaker to be adjusted.
# You cannot select speakers whose size is set
at OFF.
4 Touch a or b to select cut-off fre-
quency.
Each time you touch a or b it selects cut off
frequencies in the following order:
6380100125160200 (Hz)
Note
Selecting cut off frequencies sets cut off frequen
cies of the subwoofers L.P.F. (low pass filter) and
that of the SMALL speaker H.P.F. (high pass filter).
The cut off frequency setting has no effect if the
subwoofer is set to OFF and other speakers are
set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and AUDIO and then
touch Sound Setting.
2 Touch SP LEVEL.
3 Touch the speaker to be adjusted.
# You cannot select speakers whose size is set
at OFF.
4 Touch a or b to adjust the speaker out-
put level.
Each time you touch a or b it increases or de
creases the speaker output level. +10  10 is
displayed as the level is increased or de
creased.
Note
To adjust the speaker output levels in this mode is
the same as making the speaker output levels at
Test Tone. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and AUDIO and then
touch Sound Setting.
2 Touch Test Tone.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
Front speaker leftCenter speakerFront
speaker rightRear speaker rightRear
speaker leftSubwoofer
Check each speaker output level. If no adjust
ments are needed, perform step 4 to stop the
test tone.
# The settings do not appear for speakers
whose size is set OFF.
Section
15
79
En