Technical Data; Electrical Connections - Hotpoint Ariston AQUALTIS AQD1171D 697ID Instructions For Installation And Use Manual

Table of Contents

Advertisement

Available languages

Available languages

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the
electricity socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in
the Technical data table (see opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(see opposite);
• the socket is compatible with the plug of the
appliance. If this is not the case, have the
socket or the plug replaced.
! The machine must not be installed outdoors,
even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! The mains socket must remain within
easy reach after the Washer-dryer has been
installed.
Connect the drain
hose to drain duct
piping or a wall drain
located between 65
and 100 cm above
the floor, making sure
it is not bent at all.
Alternatively, rest the
drain hose on the
side of a washbasin
or bathtub, fastening
the duct supplied to
the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple
sockets.
! The cable should not be bent or compressed.
! The power supply cable and plug must only
be replaced by authorised technicians.
Warning! The company shall not be held
responsible in the event that these regulations
are not respected.

Technical data

Model
AQD1171D 697ID
width 59.5 cm
Dimensions
height 85 cm
depth 64.5 cm
from 1 to 11 kg for the wash
programme
Capacity
from 1 to 7 kg for the drying
programme
Electrical
please refer to the technical
connections
data plate fixed to the machine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 71 litres
up to 1600 rotations per
Spin speed
minute
Wash: programme
perature 60°C; using a load
of 11 kg.
Energy ra-
Drying: the major load (7kg)
ted
must be dried by selecting
programmes
the "EXTRA" dryness level;
according to
the remainder of the load
regulation
must be dried by selecting
EN 50229
the "EXTRA" dryness level,
the load must consist of 3
sheets and 7 pillowcases.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU (WEEE)
GB
; tem-
60°/40°
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aqualtis aqd1071d 69id

Table of Contents