Installation/Wiring Precautions - Audiovox CommanderMT 128-7902A Installation Manual

Satellite radio receiver

Table of Contents

Installation/Wiring Precautions

1. To prevent a short-circuit, be sure to turn off the ignition and remove

the negative (-) battery cable prior to installation. Connect power

wires last.

2. Do not install the CommanderMT Display Controller in loca-

tions exposed to direct sunlight, or in areas subject to extreme

temperatures, or damage could occur.

3. Incorrect installation may cause damage to the system. Mount

the system components using the suggested methods recom-

mended in this manual.

4. Be careful not to crimp or twist the vehicle wiring.

5. Use only the 12 Volt DC Power Cable supplied. Use of an alternative

power source could damage the CommanderMT System compo-

nents or vehicle wiring.

6. Locate the CommanderMT Display Controller in an area of the

vehicle where it will not obstruct the driver's operation of the vehicle

and where it will not pose a risk to driver or passengers in the event

of an emergency stop.

Table of Contents

Commandermt xmrvrfm002