Mitsubishi Electric TX10U User Manual page 41

Network settings (continued)
IP Address Settings
1. Display the IP CONFIG menu.
2. Press the or button to select IP ADDRESS.
3. Press the ENTER button.
• IP ADDRESS screen appears.
4. Press the direction buttons to move the key cursor,
select the numbers to enter, and press the ENTER
button.
• Set the numeric value within the range from 0 to
255. However, set the numeric value for the final
octet within the range from 1 to 254.
key: ............. Shifting the position of enter
cursor to the left.
key:.............. Shifting the position of enter
cursor to the right.
DEL key: .......... Deleting the character in the
position of enter cursor for each
character
CLEAR key: ..... Deleting all the entered
characters.
5. When selecting OK, the setting is completed as the
IP ADDRESS stored temporarily. However, when
selecting CANCEL, the setting is completed without
storing.
• When the setting you entered is correct, the IP
CONFIG menu is displayed. If the entered content
is not correct, the IP CONFIG menu is displayed
after an error dialog is displayed.
• Until the execution of SAVE SETTINGS, the
change is not saved.
Subnet Mask Settings
1. Display the IP CONFIG menu.
2. Press the or button to select SUBNET MASK.
3. Press the ENTER button.
• SUBNET MASK screen appears.
4. Enter the Subnet Mask.
• Refer to IP Address Settings for the detail of
entering.
5. When selecting OK, the setting is completed as the
Subnet Mask stored temporarily. However, when
selecting CANCEL, the setting is completed without
storing.
• When the setting you entered is correct, the IP
CONFIG menu is displayed. If the entered content
is not correct, the IP CONFIG menu is displayed
after an error dialog is displayed.
• Until the execution of SAVE SETTINGS, the
change is not saved.
Default Gateway Settings
1. Display the IP CONFIG menu.
2. Press the or
GATEWAY.
3. Press the ENTER button.
• DEFAULT GATEWAY screen appears.
4. Enter the Default Gateway.
• Refer to IP Address Settings for the detail of
entering.
5. When selecting OK, the setting is completed as the
Default Gateway stored temporarily. However, when
selecting CANCEL, the setting is completed without
storing.
• When the setting you entered is correct, the IP
CONFIG menu is displayed. If the entered content
is not correct, the IP CONFIG menu is displayed
after an error dialog is displayed.
• Until the execution of SAVE SETTINGS, the
change is not saved.
Saving IP CONFIG Settings
1. Display the IP CONFIG menu.
2. Press the button to select SAVE SETTINGS.
3. Press the ENTER button.
• The setting change dialog is displayed. After the
dialog disappears, the NETWORK menu is
displayed.
• It may take some time to reflect the settings.
EN-41
button to select DEFAULT