Advertisement
Quick Links
Model APS-45B
Installation Manual
Keyless Entry System
With Two Auxiliary Outputs
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems Only.
Kit Contents:
M (1) Control Module
M (2) - Three Button Transmitters
M 4 Channel Code Learning Receiver
M On Board Antenna
M (1) - Multi Pin Input/Output Harness
M (1) - Three Pin Door Lock Harness
M (1) - Two Pin LED Indicator
M (1) - Two Pin Valet / Override Switch
M (1) - 15 Amp In-line Fuse Holder With Fuse
M (1) - 5 Amp In-line Fuse Holder With Fuse
M (1) - Installation Manual
M (1) - Operator's Manual
M (1) - Limited Warranty
M (2) - Window Decals
Advertisement
Related Manuals for Audiovox Prestige APS-45B
Summary of Contents for Audiovox Prestige APS-45B
-
Page 1: Installation Instructions
Model APS-45B Installation Manual Keyless Entry System With Two Auxiliary Outputs Installation Instructions This Unit Is Intended For Installation In Vehicles With 12 Volt Negative Ground Electrical Systems Only. Kit Contents: M (1) Control Module M (2) - Three Button Transmitters M 4 Channel Code Learning Receiver M On Board Antenna M (1) - Multi Pin Input/Output Harness... - Page 2 The APS-45B Keyless Entry System is designed to provide a convenient electronic means to gain access to the vehicle by providing RF remote control over the vehicle's power door lock system. The unit also includes outputs to control the vehicle's dome lights, as well as exterior parking lights. Although not an alarm system, this unit also incudes a starter interrupt circuit output.
- Page 3 directly to the vehicle's positive parking light circuit. Once the wire is located, confirm that all the vehicle's parking lights will illuminate when +12VDC is connected to it. NOTE: Some vehicles, (mostly European) have isolated "left" and "right" side parking lights. To connect to the parking light systems in these vehicles, you must use separate SPDT relays to connect to each side in order to keep them isolated.
- Page 4 GREEN/BLACK Wire: Immediate, 300mA Duration of Transmit, Channel 4 OutputThe Green/Black wire supplies a 300mA switched output whenever Channel 4of the receiver is accessed. Pressing A combination of thetransmitter Lock/ UnLock buttons simultaneously will access Channel 4 and will remain active for as long as the transmitter button(s) is held.
-
Page 5: Programming Features
the red wire to the wire that provides a low current positive signal from the factory door unlock switch to the factory door lock control relay. The green wire provides a positive pulse during locking, or the pulsed + 12 volt lock output. Connect the green wire to the wire that provides a low current positive signal from the factory door lock switch to the factory door lock control relay. - Page 6 Programmable Features: Features 1 Chirp First Passive Arming Active Arming Second Ignition D/L ON Ignition D/L OFF Third Ignition D/UL ON Ignition D/UL OFF Fourth Chirps ON Chirps OFF Fifth Passive D/L Active D/L Sixth Siren Output Horn Output Seventh 800ms D/L Pulse 3.5 Sec.
-
Page 7: Completing The Installation
Fourth Turn the valet switch on then off Press transmitter Lock button to change Fifth Turn the valet switch on then off Press transmitter Lock button to change Sixth Turn the valet switch on then off Press transmitter Lock button to change Seventh Turn the valet switch on then off Press transmitter Lock button to change Press transmitter lock button to change... - Page 8 © 2001 Audiovox Electronics Corp. 128-6183...