Magellan ROADMATE COMMERCIAL 9270T-M User Handbook Manual page 5

General Information
Please refer to this handbook for questions on using the Magellan
Road Mate receiver. If you are still unable to answer your questions,
check our technical support web page at: http://www.magellanGPS.com/
support/.
Magellan RoadMate
Power On
A - Power Switch
B- AV In
C - Power Input
(USB)
D - Micro SO slot
Slide the power switch (A) to the left to turn the receiver on. Slide the
power switch to put the receiver into suspend mode. Slide and hold the
power switch for more than 3 seconds to turn the receiver completely off.
(Turning the receiver completely off and then back on [Power Reset] can
sometimes solve any problems encountered while using the receiver.)
The first time you use the Magellan RoadMate it may take up to 4 minutes to
compute your location under normal conditions. With adverse conditions (not
having a clear view of the sky) the time to compute your location the first time
can greatly increase.
Pairing Bluetooth®
The instructions shown here are for pairing a phone during normal use. The
first time you use Bluetooth in your Magellan Road Mate receiver, the receiver
will automatically ask you if you want to pair a phone.
After selecting Yes the receiver is in pairing mode. Follow the instructions in
your phone manual to set it in pairing mode. After the phone has searched
for new devices, select "Magellan" from the list.
Your phone will ask for a passcode. Enter '1234'.
Tap Yes on the Magellan RoadMate.
A screen will confirm the successful pairing.