Panasonic CF-74 Series Operating Instructions Manual page 17

6 Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
If [Enter Password] is displayed during the following procedures, input the Supervisor Password or the User
Password.
7 Press to execute [3. [Backup]].
3
At the confirmation message, press Y.
CAUTION
When you divide the hard disk into partitions:
Do not execute [1. [Recovery]] to divide the hard disk into partitions. The hard disk backup function cannot be
enabled after the hard disk has been partitioned. Use step 8 to divide the hard disk.
8 Select the setting.
To create a backup area and enable the backup function without dividing the hard disk
Select [1].
To create a backup area and divide hard disk into two partitions, for OS and data
Select [2]. Enter the size of operating system partition and press Enter.
• To cancel: press 0.
(The size of data partition will be determined by subtracting the operating system partition size from the
maximum size.)
9 At the confirmation message, press
The backup area is then created.
10 When the message [You must reboot in order to enable the Backup function.] appears,
remove the Product Recovery DVD-ROM, and press any key to restart the computer.
The computer restarts, then the backup process will begin.
11 When the message [[Backup] is complete] appears, press
computer.
Do not press Ctrl + Alt + Del before the message is displayed.
After logging on to Windows, a message will appear indicating that a new device has been installed and that
the computer must be restarted to enable the settings.
12 Select [Yes] to restart the computer.
NOTE
The [Boot] menu in the Setup Utility is now set to start up from the CD/DVD drive. Change it if necessary.
To perform the backup/restore function next time; "Creating/Restoring the Backup Data" (
The backup area cannot be accessed from windows.
Creating/Restoring the Backup Data
CAUTION
Before executing the backup function, execute a disk error check.
Do not interrupt the backup or restore functions. Do not turn off the power and do not press Ctrl + Alt + Del, otherwise
Windows cannot start up, or the data may be lost and the backup and restore functions may not be completed.
1 Turn on the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password or the User Password.
2 Select the [Exit] menu and select [Hard Disk Backup / Restore], and then press
At the confirmation message, select [Yes] and press Enter.
.
Y
several times while [Panasonic] boot screen is dis-
F2
+ + to restart the
Ctrl Alt Del
below).
.
Enter
17