Using The Electronic Pen (Wt615 Only - NEC wt610 Setup Manual

µ Using the Electronic Pen (WT615 only)
The electronic pen and the projector's sensors can be used to convert your whiteboard into a virtual touchscreen
which allows you to operate your projector's menu or use the ChalkBoard feature.
Important
• Be sure to set up the projector parallel to the screen. Otherwise, the actual pen stroke may not be displayed on the
screen.
• Before you use the electronic pen for the first time or when you have changed the position of the projector or the
screen size, be sure to use [Pen Calibration] to calibrate the electronic pen and the screen.
• Be sure to perform [Pincushion] correction before doing [Pen Calibration]. Otherwise, the actual pen stroke may
not be displayed on the screen.
Pen Calibration
Calibrate so that pen touches are properly detected by the sensor on the WT615.
1. Press the MENU button on the remote control or the projector cabinet.
The menu will be displayed.
2. Press the SELECT
The [Basic] menu will be displayed.
button twice to select [Setup] and press the ENTER button.
E-18