Securing The Refrigerator - Dometic RML9330 Installation Manual

RML9330 – RML9435
6.6 Install the flue duct
I
NOTE
Do not install an additional flue stack, as this leads to poor
performance and increases the power consumption of the
refrigerator.
The flue duct is installed at the factory. Follow these steps when you have
removed the flue duct and want to reinstall it (fig. g, page 7):
➤ Place the T-piece (1) on the adaptor (2) and the flue pipe (3).
➤ Direct the T-piece at an angle of 45° towards the rear wall.
➤ Attach the T-piece, adaptor and flue pipe with a screw (4).
6.7

Securing the refrigerator

!
CAUTION!
Only drill through the receptacles provided, otherwise foamed
components, including cables, can be damaged.
I
NOTE
Attach the side walls or the attached strips so that the screws are
tight, even when under increased loads (while driving).
Proceed as follows (fig. h, page 7):
➤ Move the refrigerator into its final location.
➤ Fasten the four screws (1) through the four plastic washers in the sides of
the refrigerator, and further into the wall.
➤ Put the caps (2) onto the screw heads.
6.8 Reversing the door (RML9430/9431/9435 only)
➤ Remove the control panel.
– RML9430: Unscrew the dials carefully and loosen the screws, fig. i,
page 7
– RML9431/9435: Open the refrigerator door and undo the screws
underneath the control panel, fig. j, page 7
➤ Undo the hinge screw on the top door hinge and keep it in a safe place
(fig. k, page 8).
EN
Installing the refrigerator
21