Default Naming Conventions - HP Integrity NonStop i NS2300 Planning Manual

The command interpreter input file (CIIN) is automatically invoked after the first processor is
loaded. The CIIN file shipped with new systems contains the TACL RELOAD * command, which
loads the remaining processors.

Default Naming Conventions

With a few exceptions, default naming conventions are not necessary for system resources.
However, default naming conventions have been preconfigured for the following resources to
simplify initial configuration files and automatic generation of these resources.
Type of Object
ESS disk drive
SAS disk enclosure
Modular tape drive
IP CLIM
Telco CLIM
Storage CLIM
Ethernet Adapter object
Ethernet LIF object
TCP/IP process
Telserv process
Listener process
TFTP process
WANBOOT process
SWAN/SWAN 2
concentrators
62 Default Startup Characteristics and Naming Conventions
1
Naming Convention
$ESS number
$SASnumber
$TAPE number
N group module slot
port
O group module slot
port
S group module slot
port
G group module slot
L group module slot
PIF
$ZTC number
$ZTN number
$LSN number
Automatically created by
WANMGR
Automatically created by
WANMGR
S number
Example
$ESS20
$SAS20
$TAPE01
N100241
O100243
S100233
G10027
L10027B
$ZTC0
$ZTN0
LSN0
None
None
S10
Description
Twentieth ESS disk drive in
the system
Twentieth SAS disk volume
in the system
First modular tape drive in
the system
IP CLIM which has the X1
attachment point to the VIO
enclosure located in group
100, module 2, slot 4, port
1
Telco CLIM which has the
X1 attachment point to the
VIO enclosure located in
group 100, module 2, slot 4,
port 3
Storage CLIM which has the
X1 attachment point to the
VIO enclosure located in
group 100, module 2, slot 3,
port 3
Ethernet connection in
location 100.2.7
Logical interface (LIF) for
PIF B in slot 7 in module 2
of the Group 100 VIO
Enclosure
First TCP6SAM or TCP/IP
process for the system
First Telserv process for the
system
First Listener process for
the system
None
None
Tenth SWAN/SWAN 2
concentrator in the system