Panasonic TH-50PF10WK Operating Instructions Manual page 9

TH-65PF10WK
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker terminal (R)
Note:
Make sure that the AC cord
is locked on both the left and
right sides.
– Cable fi xing bands
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note:
At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AC cord connection (see page 13)
– AC cord fi xing
Plug the AC cord
1
into the display
unit.
Plug the AC cord
until it clicks.
Fix the AC
2
cord with the
clamper which is
attached to the
unit.
Secure any excess cables with bands as required.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
Dual HDMI Terminals COMPONENT/RGB IN and
(equivalent of Dual Audio IN Terminals (equivalent
HDMI Terminal Board of BNC Component Video
(TY-FB10HMD)) Terminal Board (TY-42TM6A))
(see page 12) (see page 12)
Speaker
terminal (L)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 10)
Connections
1
2
2
Unplug the AC cord
Unplug the AC cord pressing the
two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug at
the socket outlet fi rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 11)
1
9