Panasonic Viera TH-42PV8AZ Operating Instructions Manual page 42

FAQs
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
Pictures from external equipment
are unusual when the equipment
is connected via HDMI
TV goes into
"Standby mode"
The remote control
does not work
42
Problem
•
Set "P-NR" in the Picture Menu (to remove noise). (p. 22)
•
Check nearby electrical products (car, motorcycle, fl uorescent
lamp).
•
Is "Colour" or "Contrast" in the Picture Menu set to the minimum?
(p. 22)
•
Check Colour System. (p. 27)
•
Check AV Colour System. (p. 23)
•
Reset programme. (p. 27)
•
Turn off the TV with Mains power On / Off switch, then turn it on
again.
•
Is "Sound mute" active? (p. 9)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Check Sound system. (p. 27)
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the "HDMI1 Input" setting in the Sound Menu. (p. 22)
•
If digital sound connection has a problem, select analogue sound
connection. (p. 39)
•
Is the HDMI cable connected properly? (p. 36)
•
Turn Off the TV and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 40)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
Off Timer function is activated.
•
The TV enters "Standby mode" about 30 mins. after broadcasting
ends.
•
Are the batteries installed correctly? (p. 6)
•
Has the TV been switched On?
Actions