Panasonic TH-42PH12L Operating Instructions Manual page 9

For TH-42PH12L, TH-50PH12L
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Speaker
terminal (R)
– AC cord fi xing
Note:
Make sure that the AC cord
is locked on both the left and
right sides.
– Cable fi xing band
Secure any excess cables with band as required.
Note:
One fi xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.
Pass the attached cable
fi xing band through the clip
as shown in the fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AC cord connection (see page 14)
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
2 it clicks.
Fix the AC cord with
2
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
R AUDIO L R AUDIO L VIDEO
S VIDEO
B AV IN A
SLOT2
Dual Video Terminals COMPONENT/RGB IN and
(equivalent of BNC Audio IN Terminals (equivalent
Dual Video Terminal of BNC Component Video
Board (TY-FB9BD)) Terminal Board (TY-42TM6A))
(see page 12) (see page 13)
Speaker
terminal (L)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob
pressed.
To loosen:
To tighten:
Push the catch
Pull
R AUDIO L
P /C /R P /C /B Y/G
R R B B
COMPONENT/RGB IN
SLOT3
From EXTERNAL
monitor terminal
on Computer
(see page 10)
Connections
1
2
2
Unplug the AC cord
Unplug the AC cord
pressing the two
knobs.
Note:
When disconnecting the AC cord, be
absolutely sure to disconnect the AC
cord plug at the socket outlet fi rst.
Pull
AUDIO
PC IN SERIAL
From SERIAL
Terminal on
Computer
(see page 11)
1
9