Voice Recognition; Using Voice Recognition; Starting Voice Recognition; Skipping Prompt Messages - Hyundai ELANTRA 2016 Owner's Manual

VOICE RECOGNITION

Using Voice Recognition

Starting Voice Recognition

Shortly press the key on the
steering wheel. Say a command.
If prompt feedback is in [ON], then
the system will say "Please say a
command after the beep (BEEP)"
• If prompt feedback is in [OFF]
mode, then the system will only
say "(BEEP)"
• To change Prompt Feedback
[On]/[Off], go to
SETUP
[Prompt Feedback]
✽ ✽ NOTICE
For proper recognition, say the com-
mand after the voice instruction and
beep tone.
Contact List Best Practices
1) Do not store single-name entries
(e.g., "Bob", "Mom", "Kim", etc.).
Instead, always use full names
(including first and last names) for
all contacts (e.g., use "Jacob
Stevenson" instead of "Dad").
2) Do not use abbreviations (i.e., use
"Lieutenant" instead of "Lt." or
"Sergeant" instead of "Sgt.").
3) Do not use acronyms (i.e., use
"County Finance Department"
instead of "CFD").
4) Do not use special characters
(e.g., "@", "hyphen -", "asterisk *",
"ampersand &").
5) If a name is not recognized from
the contact list, change it to a
[System] more descriptive name (e.g., use
"Grandpa Joseph" instead of "Pa
Joe").
Features of your vehicle

Skipping Prompt Messages

While prompt message is being stat-
ed Shortly press the key on the
steering remote controller
The prompt message is immediately
ended and the beep tone will sound.
After the "beep", say the voice com-
mand.
Re-starting Voice Recognition
While system waits for a command
Shortly press the key on the
steering remote controller
The command wait state is immedi-
ately ended and the beep ton will
sound. After the "beep", say the voice
command.
4 175