No Mounting Hardware Used; Reboot The Server - HP STOREEVER LTO 4 User Manual

1. Push the server latch down to lock the tape drive into position, as shown in the following
figure.
Figure 20 Securing drive, mounting hardware used
1. Plastic rail
2. Server latch
2. Ensure that blanking plates are in place over empty bays and replace the cover on the server.

No mounting hardware used

1. If the drive is secured with fasteners, use a PoziDrive #1 screwdriver to secure the 4mm M3
screws provided with the tape drive. If the server sheet metal is less than 1.5mm thick, use
the screws and washers provided in the GENERAL MOUNTING SCREWS screw pack so
the screws can be tightened without damaging the drive. (The washers are not needed if
the server sheet metal is at least 1.5mm thick.)
Figure 21 Securing drive, no mounting hardware used
1. M3 screws, supplied with tape drive
2. Ensure that blanking plates are in place over empty bays and replace the cover on the server.

Reboot the server

Reboot the server to power up the tape drive and server.
24 Installing an internal LTO Ultrium tape drive