D-Link DAP-2310 Quick Install Manual page 5

DAP-2310 to your network
1. Connect the power adapter to the receptor on the rear panel of the
DAP-2310 and then plug the other end of the power adapter to a wall outlet
or power strip. The power LED will turn ON to indicate proper operation.
Note: If you are going to connect the DAP-2310 to a Power over Ethernet
(PoE) switch, do NOT connect the power adapter.
2. Using an Ethernet cable, insert one end of the cable to the LAN port on the rear
panel of the DAP-2310 and the other end of the cable to a switch or router's
LAN port .
Note: You can also connect the DAP-2310 directly to the computer that will
be used for configuration. The LAN LED will illuminate to indicate a proper
Ethernet connection.
3. Computers with 802.11 b/g/n wireless adapters can connect to the DAP-2310.
Connecting the
Desktop
RESET
LAN(PoE)
DAP-2310
RESET
LAN(PoE)
Monitor
12V 1A
1
2
Switch
12V 1A
5 5