Table of Contents
Advertisement
∫ Folder Composition
The folder structure of the built-in memory,
the card or MultiMediaCard is displayed as
the illustration below.
≥Built-in memory
≥SD Memory Card
≥MultiMediaCard
1 Folder number
2 File number
3 JPG: pictures
MOV: motion images
Files will be saved in each folder as follows.
DCIM
Folders from [100_PANA] to
[999_PANA]
100_PANA
Pictures/motion images
MISC
Files on which the DPOF
print settings are recorded
• When recording, up to 999 picture data
can be included in 1 folder. If the number
of picture data exceeds 999, another
folder will be created.
• When you reset the file number or the
folder number, select [NO.RESET] in the
[SETUP] menu. (P23)
• If the remaining battery power is
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use
batteries with sufficient battery power
(P13) or the AC adaptor (DMW-AC2;
optional).
84
VQT0Q78
Connecting to a PC or Printer
DCIM
100_PANA
1
100_PANA
P1000001.JPG
2
3
P1000002.JPG
P1000999.JPG
101_PANA
999_PANA
MISC
• If the remaining battery power becomes
low during communication, the status
indicator blinks and the alarm beeps. In
this case, stop the communication at
once.
• While [ACCESS] is being displayed, do
not disconnect the USB connection cable.
• When the OS of your PC is Windows
2000 and you connect the camera to
the PC with the USB connection cable,
do not replace the card with the
camera connected to the PC. The
information in the card may be
damaged.
• Do not use any other USB connection
cables except the supplied one.
• For more information, refer to the separate
operating instructions about PC
connection.
• Also refer to the operating instructions of
the PC.
• If the card is not inserted when the
camera is connected to a PC, you can edit
or access the picture data in the built-in
memory. If the card is inserted, you can
edit or access the picture data in it.
• You cannot switch the recording medium
between the built-in memory and the card
while the camera is connected to the PC.
When you want to switch the recording
medium, disconnect the USB connection
cable, insert (or remove) the card and
then connect the USB connection cable to
the PC again.
∫ PictBridge (PTP) setting
Even if you set the [USB MODE] to
[PictBridge (PTP)], you can connect to the
PC only when the OS is Windows XP
Home Edition, Windows XP Professional or
Mac OS X.
• You can only load pictures from the
camera and cannot write them on the card
or delete them.
• When there are 1000 or more pictures on
a card, the pictures may not be imported.
Advertisement
Table of Contents
