Moisture Selector - Monogram ZW9000 Owner's Manual

Control
knob
ON signal
light
Moisture
selector
The warming drawer controls are hidden with the
drawer shut. Open the drawer. The controls are
on the right side of the front frame.
To use the warming drawer, press the ON/OFF
switch to the ON position.
Slide the moisture selector control to the open or
closed setting. (See the Moisture Selector section.)
Turn the control knob clockwise to the desired
setting.
PROOF . . . . . 75–95°F.
LOW . . . . . . . 140–160°F.
The ON signal light is located below the ON/OFF
switch and glows when the ON/OFF switch is
in the ON position. It stays on until the ON/OFF
switch is moved to the OFF position.
The moisture selector is located on the inside
front of the drawer.
To keep foods moist, slide the moisture selector
control away from the control knob. This closes
the vent and seals the moisture inside the drawer.
With the vent closed hot foods stay moist and
soft.
In this setting condensation may occur around
the inside edge of the drawer.
To keep foods crisp, slide the moisture selector
control to the right towards the control knob.
This opens the vents and allows the moisture to
escape.
With the vents open, it is normal for moisture to
collect on surfaces above the warming drawer.
MED . . . . . . . 160–195°F.
HIGH . . . . . . 195–230°F.
Using the Warming Drawer
Electric Warming Drawer
The ON signal light is visible through the light
viewer in the drawer front panel when the drawer
is closed. This is a reminder that the heat is on.
11