Auto Tune - Panasonic TX-68P200A Operating Instructions Manual

Tuning Menu

Auto Tune

This television has been factory tuned to all major city channels. Use the automatic tuning procedure only if you
wish to reset ALL Programme Location Numbers. Refer to "Manual Tune" on page 27 if you only want to retune one
or two Programme Location Numbers.
The television should be switched ON and the TV/AV Switch set to TV.
When you start the automatic search, the television will automatically search for television broadcasts through both
VHF bands and the UHF band. During this process all of the available television broadcast channels will be
automatically allocated to sequential Programme Number locations depending on the mode selected (See page 25).
Using the Front Panel
1. Push the button repeatedly until the Tuning
Menu is reached. (See page 22).
2. Push the or
Menu.
3. Push the button to access Auto Tune.
TUNING MODE
F : NO
STR F
4. Push the or
The television will automatically allocate each received broadcast signal to a Programme Number. As
each station is stored the Panasonic logo will appear momentarily. The operation will cease when all
available channels have been tuned.
29
CH 29
AUTO SETUP IN PROGRESS
SEARCHING :
STORED CH29
F : RETURN TO TUNING MENU
TV/AV : TO EXIT
Push the button to return the television to the
Tuning Menu.
Push the TV/AV
24
Button to access the Tuning
- , + : YES
-/\/ +//\ TV/AV
Button to start the search.
button to return the television to normal operation.
Using the Remote Control
1. Push the Set Up ( ) button.
2. Push the or
Tuning Menu. (See page 22).
3. Push the or
Menu.
4. Push the or
Tune.
5. Push the or
29
CH 29
AUTO SETUP IN PROGRESS
SEARCHING :
STORED CH29
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
Push the Set Up ( ) button to return the television to
the Tuning Menu.
button to select the
button to access the Tuning
button to select the Auto
button to start the Auto Tune.