HP 5500 SI Troubleshooting Manual page 26

Port Power Enabled
Port Power Priority
Port Operating Status
Port IEEE Class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak Power
Port Max Power
Port Current
Port Voltage
Port PD Description
If the current power, average power, and peak power of the PoE interface are close to or reach
the maximum power of the PoE interface, execute the poe max-power command to configure
the maximum power with higher-wattage supply.
2. If the problem persists, contact HP Support.
Related commands
This section lists the commands that you might use for troubleshooting PoE.
Command
display poe device
display poe interface interface-type
interface-number
display poe pse
poe legacy enable pse
poe max-power
: disabled
: low
: off
: 0
: disabled
: signal
: 0
: 0
: 0
: 30000
: 0
: 0.0
:
Description
Displays PSE information.
Displays power supply information for PoE interfaces.
Displays detailed PSE information.
Enables the PSE to detect nonstandard PDs.
Configures the maximum power for a PoE interface.
26
mW
mW
mW
mW
mA
V