Battery Installation; Battery Charge - Panasonic KX-TG1811 Operating Instructions Manual

TG1811_1812_1813AL(e-e).book Page 9 Friday, May 12, 2006 2:25 PM

Battery installation

Important:
L Wipe the battery ends (S, T) with a dry
cloth.
L Install the batteries without touching the
battery ends (S, T) or the unit contacts.
Insert the batteries negative (T) terminal
first. Close the handset cover.
Note:
L Use only the included rechargeable
batteries (page 3, 4).
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.

Battery charge

Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Battery icon Battery strength
Fully charged.
054
High
5
Medium
6
Low
7
Needs to be charged.
074
Panasonic Ni-MH battery performance
Operation
In continuous use
In continuous standby
mode
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Preparation
Operating time
Approx. 10
hours max.
Approx. 120
hours max.
9