Panasonic DMR-E500H Operating Instructions Manual page 55

7
Press [3, 4] to select "Manual" and
press [ENTER].
When connecting via a router with its DHCP enabled
Select "Automatic (DHCP)" in this step. (Step 8–10 are
unnecessary. Go to step 11.)
SETUP TCP / IP Settings
IP Address .
Tuning
Subnet Mask .
Others
Default Gateway .
Disc
DNS Server
.
Picture
Sound
Press "Set" to store the values after input.
Display
8
Press [3, 4] to select "IP Address"
and press [ENTER].
9
Press the numbered buttons to enter
the number and press [ENTER].
≥Press [2, 1] to move the cursor.
≥Press [¢ CANCEL] to clear the numbers.
Repeat step 8 and 9 to enter "Subnet Mask", "Default
Gateway" and "DNS Server" numbers.
IP Address
If the computer's IP address is 192.168.0.15, enter 192.168.0.
and then enter an arbitrary number, except 15, between 2 and
254 (➡ page 54, left column, step 4).
Subnet Mask
Enter the same set of digits as the computer's Subnet mask
(➡ page 54, left column, step 4).
Default Gateway
Enter the same set of digits as the computer's Default
gateway (➡page 54, left column, step 4).
DNS Server
Enter the same set of digits as the computer's Preferred DNS
server (➡ page 54, left column, step 4).
Example:
§
192.168.0.14
IP Address :
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.0.1
DNS Server: 192.168.0.1
§
Make a note of this IP address. You will need it when
operating this unit from the computer (➡page 56, step 1).
10
Press [3, 4] to select "Set" and
press [ENTER].
11
Confirm that a connection has been
established.
y
Display
Now searching. . .
Connection
SELECT TAB
Network
ENTER
RETURN
Wait until the display changes (this may take a few minutes).
≥"Now connected to the network." is displayed if the
connection has been correctly established.
≥"Cannot connect to the network." is displayed if the
connection has failed. Check the LAN cable connection.
To exit the screen
Press [RETURN] several times.
To return to the previous screen
Press [RETURN].
]Note]
≥While "Now updating the settings. Please wait for a while." is
displayed, no operations will be accepted by this unit. Wait about 5
seconds until the highlights appear again.
≥When "Automatic (DHCP)" is selected for the TCP/IP setting, the IP
address changes randomly everytime you turn the unit off then on
again. But this is not a problem because the computer can
recognize new IP address.
. .
. .
. .
. .
Set
RQT7755
55