Installation and wiring
3.4 Wiring of the FP-FMU Connectors
3.4.1 FP7 PROFIBUS DP Master
3.4.2 FP7 DeviceNet Master
Open style connector/suitable wire
Precautions
20
Use a standard PROFIBUS cable and standard 9-pin Sub-D male PROFIBUS
connectors.
DeviceNet has a standard open style connector.
If additional connectors are needed, use the standard CAN 5-pin open style
connectors manufactured by Phoenix Contact.
No. of contacts Phoenix Contact model no.
5
MSTB 2,5/ 5-ST-5,08 ABGY AU
Terminal block for DeviceNet
Use a standard DeviceNet cable.
When removing the wire's insulation, be careful not to scratch the core
wire.
Do not twist the wires to connect them.
Do not solder the wires to connect them. The solder may break due to
vibration.
After wiring, make sure no wire is under stress.
Phoenix Contact product no.
1849037
FP7 Fieldbus Master Units Technical Manual