Telefunken TD 251/TD 252 Colombo Quick Start Manual page 15

Activation
Connecting the base
1. Under the base, plug the power cord
holding a clear connector in the plug
labeled .
2. Connect the other end of the power
cord into the power wall outlet. The
device switches on, as indicated by
the green light from the base.
3. Under the base, connect the
telephone jack to the plug labeled
and the other end into the telephone
connector plug. Then plug the
connector to the telephone wall jack.
4. Verify that the green light of the base
is lit.
Recharging the handset
1. On the handset, slide the cover and
insert the 2 NiMH batteries supplied.
Always observe the direction of
insertion. Close the lid.
2. Place the handset on the base and
allow to charge for at least 24 hours
before its first use, until the handset
icon indicates
3. If necessary, do the same for other
handsets.
.
Checking the line
Once the is displayed on the handset,
lift the handset and check for the dial tone.
Setting the language
To facilitate the following settings, proceed
first to the selection of menus in French.
1. Press Menu. Using , go to Settings
and press Select.
2. Handset Settings will be highlighted,
press Select.
3. Using , highlight Language and press
Select.
4. Using  or , select the desired
language. Press Select to confirm.
5. Press Back to return to the previous
level.
Setting the date and time
If Caller ID was purchased from your
service provider, the date and time are
automatically displayed on the handset.
If the Caller ID function has not been
purchased, use specific menu to adjust
time and date.
15