SB PCB
1. Removal of cords/tapes
・Take off the two cord arranging tapes (717).
・Remove the one cord arranging tape (716).
・Remove the lead wire [black] and the lead wire [red].
2. Removal of harness
・Remove the SB control harness (1013) from the connector.
3. Removal of condenser/microphone/SB PCB
・Remove the condenser.
・Remove the connector (Fig. 1) and then remove the microphone (1023).
・Take off the SB insulating sheet (711).
・Remove the two screws (804).
・The SB PCB can be removed.
- D10 ・ E7900 -
VAA46003-R.3659.A