Maintenance - Black & Decker BDEBCS14 Instruction Manual

OPeRATION TIPS fOR MORe ACCURATe CUTS
• Allow the wheel to do the cutting. Excessive force will cause the wheel to glaze reducing
cutting efficiency and/or to deflect causing inaccurate cuts.
• Properly adjust fence angle.
• Make sure material is laying flat across base.
• Properly clamp material to avoid movement and vibration.

MAINTeNANCe

MOTOR BRUSh INSPeCTION AND RePLACeMeNT (fIg. L)
WARNINg:
To reduce the
risk of injury, turn unit off and
disconnect machine from power
source before installing and
removing accessories, before
adjusting or changing set-ups or
when making repairs. Be sure the
trigger switch is in the Off
position. An accidental start-up
can cause injury.
Brushes should be regularly
inspected for wear. To inspect
brushes, remove brush cap (19).
Brushes (20) should slide freely in brush box. If brushes are worn down to .3 inch
(8mm) as shown in figure L they should be replaced. To reinstall, push new brush
back into brush box. If replacing existing brush, maintain same orientation as when
removed. Replace the brush cap (do not overtighten).
CLeANINg
WARNINg:
Blow dirt and dust out of the main housing with dry air as often as dirt is
seen collecting in and around the air vents. Wear ANSI Z87.1 (CAN/CSA Z94.3) approved
eye protection when performing this procedure.
CAUTION:
When cleaning, use only mild soap and a damp cloth on plastic parts.
Many household cleaners contain chemicals which could seriously damage plastic. Also,
do not use gasoline, turpentine, lacquer or paint thinner, dry cleaning fluids or similar
products which may seriously damage plastic parts. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
RePAIRS
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
should be performed by authorized service centers or other qualified service organizations,
always using identical replacement parts.
LUBRICATION
Closed-type, grease-sealed ball bearings are used throughout. These bearings have
sufficient lubrication packed in them at the factory to last the life of the chop saw.
SeRvICe AND RePAIRS
All Black & Decker Service Centers are staffed with trained personnel to provide customers
with efficient and reliable power tool service. Whether you need technical advice, repair,
or genuine factory replacement parts, contact the Black & Decker location nearest you. To
find your local service location, call 1-800-544-6986 or visit www.blackanddecker.com
ACCeSSORIeS
Use only high-strength Type 1 organic bonded wheels rated 4100 rpm or higher.
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNINg:
The use of any accessory not recommended for use with this tool could
be hazardous.
L
20
.3"
(8mm)
8 8
20
19