Advertisement
4
Instrument Panel
1
4
Lighting Control
Power-Adjustable Foot Pedals*
Switches on the headlamps.
Your power-adjustable pedal control, on the left
of your steering column, allows you move your
Switches the headlamps off.
brake and accelerator pedals. Press the
Switches on the parking lamps.
to move the pedals away from you or the
Autolamps*: Turns the headlamps on
to move the pedals closer to you.
and off based on available daylight.
Note: Adjust the pedals only after you stop the
2
Interior Lamps
vehicle and place the transmission in park (P).
Press and hold the top of the control to
5
Cruise Control
switch on the interior courtesy lamps. Press
To set the speed:
the bottom of the control to switch off the
interior lamps.
A. Press and release ON.
3
B. Drive to the desired speed.
Tilt and Telescoping Steering Column
C. Press SET+ and take your foot off
Use the control on the side of the steering column
the accelerator.
to adjust the position. The column automatically
To set a higher or lower speed, press and
moves to the full up position when you switch
hold SET+ or SET– until you reach the desired
the ignition off. It returns to the previous position
speed. Press and release either button to
when you switch the ignition on. You can switch
change a set speed in approximately
this feature off in the information display. For
1 mph (2 km/h) increments.
more details about your information display
functions, please see your Owner's Manual.
To cancel a set speed, tap the brake pedal.
The set speed saves for easy recall.
To return to a previously set speed, press RSM.
To switch off, press OFF or switch the
ignition off.
2 01 7 N A V I G A T O R
6
Autowipers
To switch this feature on, move the wiper controls
to intermittent wipe. The autowiper system turns
⊳
arrow
the wipers on only when moisture is present on
⊲
arrow
the windshield. The wiper speed depends on
how much moisture the system detects and the
sensitivity setting.
Low sensitivity turns the wipers on when the
rain sensor detects a large amount of moisture
on the windshield.
High sensitivity turns the wipers on when the
rain sensor detects a small amount of moisture
on the windshield.
To switch this feature off, use your wiper
controls. To change this feature to intermittent
wipe every time you use your wipers, use the
information display.
To switch intermittent wipe back to autowipers,
use the information display.
Note: Make sure you switch this feature off
before entering a car wash.
5
*if equipped
Advertisement
