Power And Sound Controls - Panasonic CQ-DFX202N Operating Instructions Manual

Power and Sound Controls

Power
Turn the key in the ignition until the accessory indicator lights.
Power on : Press [SOURCE] (PWR).
Power off : Press [SOURCE] (PWR) again and hold.
The panel removal alarm sounds.
Note: When the power is switched on for the first time, a
demonstration message appears on the display.
To cancel this display, press [DISP].
Remote control
sensor for an
optional remote
control.
Volume
[}VOL] : Up
[{VOL] : Down
Press and hold for rapid
adjustment.
Volume Level (0 to 40)
Note: When the power is
switched off and on again, the
volume slowly rises to the
previous level.
Level Meter
q
Press and hold [SEL] to change to the display
control mode. ("PATTERN" appears on the dis-
play.)
Press and hold [SEL]
Regular Mode Level Meter
w
Press [[TUNE] to select a level meter pattern.
Pattern 1 Pattern 2
Pattern 5
(Pattern off)
( []TUNE]: opposite direction)
(a Page 19)
REMOTE REMOTE
BAND
VOL VOL
TUNE TUNE
SEL SEL
TRACK TRACK
LOUD LOUD
1
DISP DISP
Press [SEL]
Panel Removal Alarm
(a Page 19)
Pattern 3
Pattern 4
CQ-DFX202N
RANDOM SCAN
2 3 4 5 6
R SCAN REP
Loudness
Press [LOUD] to enhance bass and treble tones at low or
medium volume.
Press [LOUD] again to cancel.
Note: The sound can be muted with the optional remote
controller. (Read the remote controller manual for instruc-
tions.)
Audio Mode
(Bass/Treble/Balance/Fader)
q
Press [SEL] to select the audio mode.
Modes change as follows:
Regular Mode
w
Press [}VOL] or [{VOL] to change each level.
B B A A S S + + 3 3 d d B B
Bass
T T R R E E + + 3 3 d d B B
Treble
B B A A L L L L 2 2
Balance
F F A A D D F F 3 3
Fader
Note: If no operation takes place for more than 5 seconds
in the audio mode (2 seconds in Volume mode), the display
returns to Regular Mode.
OPEN
MONO/LOC
PTY
PWR
SOURCE SOURCE
EON E PTY E CT
TA
AF
SUB·W
Volume Bass
Fader
(–12 to +12)
(–12 to +12)
(Left / Right: 1 to 15)
(Front / Rear: 1 to 15)
CQ-DFX202N
E
N
G
L
I
S
H
2
Treble
Balance
7