Procedure For Speaker Settings (Audyssey ® Setup) - Denon AVR-X4300H Owner's Manual

Contents Connections
Procedure for speaker settings
(Audyssey ® Setup)
Preparation
Measurement
Calculation & Store
Front panel Display
Playback
Check
Finish
Rear panel
Settings
1
Attach the Sound calibration microphone to the
supplied microphone stand or own tripod and install it
at the main listening position.
When installing the Sound calibration microphone, point the tip of
the microphone toward the ceiling and adjust the height to match the
height of the ears of a listener in a seated position.
2
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
n When using a subwoofer with a direct mode
Set the direct mode to "On" and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
Volume : 12 o'clock position
0
Crossover frequency : Maximum/Highest Frequency
0
Low pass filter : Off
0
Standby mode : Off
0
210
Remote
Tips Appendix
Index