Setting The Child Lock [Child Lock]; Maintenance; Water Supply Filter; If The Water Supply Hose Is Frozen - Panasonic NA-140ZS1 Operating & Installation Instructions Manual

Changing Appliance Settings
Setting the Child Lock
Child Lock
You can lock the door to prevent
children from opening it themselves.
This also locks the operation buttons.
1
Turn on the power.
2
Press for at least 5
seconds.
(B A lights up.)
■To deactivate
Press for at least 5
seconds.
(B A disappears.)
NOTE
●
Ignore the beeps and keep "Option"
pressed until the Child Lock is
deactivated.
32

Maintenance

(continued)
Clean the filter if water is not supplied
properly.
1 Turn off the tap.
2 Turn on the power and start the
"Cotton" programme without any
laundry or detergent inside the
drum. (P.17)
3 After 1 minute, turn off the power.
Water has drained out of the water
supply hose.
4 Remove the water supply hose and
clean the water supply filter.
■If the hose is fitted with a water
supply valve
Also remove the hose from the tap and
clean the water supply filter at that end
too.
Hose with water supply
valve fitted

Water supply filter

If the water supply hose is frozen

1 Wrap warm towels around the joints
Water supply filter
2 Put 2 to 3 litres of hot water (about
Brush etc.
3 Select D in "Mode" (P.27), and
Water supply filter
●
Filter
Maintenance
of the water supply hose.
Joints
Water supply hose
50 °C) into the drum.
start operation.
NOTE
If the appliance is delivered in
freezing weather conditions, leave it
indoors for about 24 hours before
using it. This will allow any ice inside
the hose to melt.
33