Operation - Makita BO6040 Instruction Manual

3
1 2
1. Dust outlet
2. Cuff
3. Hose
1
1. Joint

OPERATION

8
Dust collection (optional accessory)
003328
If a Makita hose is used, you can connect the cuff to the dust outlet directly.
If other hose with an inner diameter of 24 mm, attach the joint between the
003329
dust outlet and the cuff.
Sanding operation
003338
CAUTION:
• Never switch on the tool when it is in contact with the workpiece, it may
cause an injury to operator.
• Never run the tool without the abrasive disc. You may seriously damage
the pad.
• Never force the tool. Excessive pressure may decrease the sanding
efficiency, damage the abrasive disc or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it attains full speed. Then
gently place the tool on the workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
Polishing operation
CAUTION:
• Use only a Makita genuine sponge pad, felt pad or wool pad (optional
accessories).
• Always operate the tool at low speed to prevent work surfaces from
damage/burning.
• Never force the tool. Excessive pressure may decrease the polishing
efficiency and cause motor overload, resulting in tool malfunction.