Related Manuals for Sealey MIGHTYMIG 100
Summary of Contents for Sealey MIGHTYMIG 100
- Page 1 MIG WELDER INSTRUCTIONS FOR: MIGHTYMIG 100 MODEL NO: Original Language Version MIGHTYMIG100 Issue: 2 - 26/02/10...
- Page 2 It is particularly important to use an RCD together with portable products that are plugged into an electrical supply not protected by an RCCB. If in doubt consult a qualified electrician. You may obtain a Residual Current Device by contacting your Sealey dealer. You must also read and understand the following instructions concerning electrical safety.
- Page 3 DO NOT operate the welder if it or the cables are damaged and DO NOT attempt to fit any unapproved torches or other components to the welder. DO NOT get welder wet or use in damp or wet locations or areas where there is condensation. ...
- Page 4 fig.4 fig.5 fig.3 3.1.7 Referring to fig.4, move the pressure roller moulding back round onto the grooved drive wheel and swing down the wire lock screw to lock it in place. See section 3.2 regarding wire tension. 3.1.8 Feeding the wire through to the torch. (See fig.5) Remove gas cup (a) and contact tip (b) from end of torch as follows: a) Take torch in left hand with the torch tip facing to the right. b) Grasp gas cup firmly in your right hand. c) Turn gas cup clockwise only and pull cup out to the right. WARNING! do not turn gas cup anti-clockwise, as this will damage internal spring.
- Page 5 To keep the contact tip free from spatter, we recommend the use of anti-spatter spray (MIG/722307) available from your Sealey dealer. 6.6. Replacing wire liner: 6.6.1 A worn or damaged wire liner will seriously affect the performance of the welder and should be...
- Page 6 WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode. Sole UK Distributor, Sealey Group, www.sealey.co.uk...